TT-01 Type-E Steering Knuckle TT01-E37/LB for tuning and repair by 3Racing  [TT01-E37/LB]

Tamiya TT-01 TYPE-E Knuckle Arm - 3RACING TT01-E37/LB
Price:
USD$12.60
Brand:
3Racing
Model:
TT01-E37/LB
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical overview for TT-01 Type-E knuckle

The TT01-E37/LB knuckle arm is produced as a direct replacement for the Tamiya TT-01 Type-E steering assembly. It maintains stock mounting dimensions and is intended for service use, restoring correct pivot positions and steering linkage alignment for competitive or club-level setups.

Installation follows standard procedure: remove wheel and hub, unbolt the existing knuckle from the suspension upright and steering link, then transfer bearings and retaining hardware. Ensure pivot clearances and bearing seating are correct to avoid play that could affect steering precision.

From a setup perspective the knuckle provides the rigid steering interface needed when tuning toe and scrub radius via tie rods and shock positions. It should be used as part of a wider suspension setup process rather than as an isolated performance upgrade. Verify alignment and torque values before track testing.

Which TT-01 chassis is supported?

Supported application is the TT-01 Type-E variant; confirm chassis designation and mount geometry prior to installation to ensure compatibility.

Are there recommended torque values?

Tighten steering fasteners to secure fit without overloading plastic components; use common RC hardware torque practice and recheck after initial testing to prevent loosening under load.

Material and durability considerations?

This replacement is designed for routine service life and accurate fit; inspect for wear when swapping bearings and replace any degraded hardware to maintain consistent steering response.