XRAY NT1 Graphite Battery Tray Technical Fit XN1-18/WO by 3Racing  [XN1-18/WO]

Team XRAY NT1 Graphite Battery Tray - 3RACING XN1-18/WO
Price:
USD$11.90
Brand:
3Racing
Model:
XN1-18/WO
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical graphite battery tray for NT1 installations

This graphite battery tray is engineered to interface with the XRAY NT1 1/10 touring car battery bay, providing a stiff platform for common pack geometries. It is intended as an aftermarket mounting solution to lock pack position and assist consistent mass distribution for setup work.

Integration uses the NT1 battery zone and existing chassis fastener points; verify hole alignment and chassis revision before final assembly. For setup tuning, consider measured fore/aft and lateral pack shifts as the way to alter balance rather than relying on the tray as a handling modifier by itself.

Graphite was selected for dimensional stability and a modest reduction in mass compared with typical injection-molded plastics, which helps maintain repeatable chassis behaviour across sessions. The component is for RC model applications only and should not be used on road vehicles.

What checks are recommended before fitting?

Confirm chassis revision and verify that the tray aligns with mounting holes and clearance points; minor trimming of non-structural chassis elements may be needed on some early or modified NT1 layouts.

Any torque or fastening guidance?

Use appropriate low-profile screws and moderate torque to avoid compressive stress on graphite edges; secure fasteners evenly and recheck torque after initial running.

How should I use this during setup tuning?

Treat the tray as a stable reference for measurement: document battery position, test incremental fore/aft shifts and log handling changes to find the best balance for your track and setup.